The PROII and the original PRO use different default (hex) addresses, but they are changeable in both DXbase and the radio. I think the PRO is 5C, and the PROII is 64. N5IN is the expert at Icom settings in the radios.ini file. The important consideration is that the address in the radios.ini file and the radio must be the same.
For my PROII, I'm using 19200/N/8/1. The setting for DTR/RTS/CTS varies with the type of interface. For my K1NU cable/interface, I need RTS high. For my RIGblaster Pro, which I used previously, none of those is checked. I don't have the expensive ICOM CIV unit. Jim N7US -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Brent Sent: Friday, February 18, 2005 10:19 PM To: [email protected] Cc: [EMAIL PROTECTED] Subject: Re: [Dxbase] ICOM 756 Pro question Jack, This is what I have setup for my ProII which should be the same. CI-V Baud Rate 19200 CI-V Address 64h CI-V Transceive On CI-V with Ic-731 Off In DXbase I have com1, 19200 8,N,1 and DTR and RTS are checked. Hope that helps you. -Brent N9BC www.hamshacks.com ----- Original Message ----- From: "Jack" <[EMAIL PROTECTED]> To: <[email protected]> Cc: <[EMAIL PROTECTED]> Sent: Friday, February 18, 2005 5:24 PM Subject: [Dxbase] ICOM 756 Pro question > Anyone got one of these who can tell me what radio options to set in > DXbase. Also, what address should be in the radio. > > Got someone having difficulty and not sure what to do. His radio > reports > it is using 64H but that seems wrong to me??? > > TIA > > Jack > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
