----- Original Message ----- From: "chen xueqin" <[EMAIL PROTECTED]> To: "eci maillist" <[email protected]> Sent: Saturday, September 17, 2005 5:12 PM Subject: [ECI] D-link DSL-200 Ver:A2 modem probrem in SuSe 9.3
> Hi folks: > I want to use internet uder SuSe 9.3 linux box. I have a D-link DSL-200 > Ver(A2) modem. > This modem works well on WinXP with following config: > Encapsulation - RFC 2516 PPPoE > Modulate = Multimode > > I downloaded eciasl-usermode-0.11beta1 driver, config it in graphy user > interface. > Then use "eciadsl-start" command, it report connect ok, say waiting for > tap0. > When I use ifconfig -a to see all the interface, I found it says like these > > tap0 Link encap:Ethernet HWaddr 00:FF:A5:69:2E:F6 > inet6 addr: fe80::2ff:a5ff:fe69:2ef6/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:308 (308.0 b) > > No inet4 addr, I think it's incorrect. > in bridged mode, the bridge don't need to have an ip address. With PPPoE, this is ppp0 wich will receive the address supplied by the ISP. > When I use route to see the route table, no route for tap0. > > So that's the problem, I can't use tcp/ip use tap0 interface. > you are not at the ip level in bridged mode > What's wrong? > 1. I can't find Encapsulation - RFC 2516 PPPoE in eciadsl config, how to set > it accordingly? > It has only 5 options > VCM_RFC2364 > LLC_RFC2364 > LLC_SNAP_RFC1483_BRIDGED_ETH_NO_FCS > VCM_RFC_1483_BRIDGED_ETH > LLC_RFC1483_ROUTED_IP > VCM_RFC1483_ROUTED_IP > So does the modulate config. > RFC1483 was deprecated by RFC2516, RFC differences look minor. You probably need LLC_SNAP_RFC1483_BRIDGED_ETH_NO_FCS > 2. tap0 can be created , but no route via it? Why > you are not at the ip level in bridged mode pppd will set the route later if defaultroute option is used. If you don't have an answer during PPPoE start, your problem probably is adsl synchronization as it is a bit special with eciadsl. Try other sync files. Other troubles may be bad VPI/VCI value (same no answer) or bad login/password (this time the message is authentification failure). Gilles =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- Driver Linux pour modem ECI ADSL USB: http://eciadsl.flashtux.org Archives de cette liste de diffusion: http://liste.eci.free.fr Pour se desinscrire: mailto:[EMAIL PROTECTED]
