Brief Problem Description: Community Edition 2.1.2 installation successful to the "setup - configuration" point, then reboots to the console without running the setup (not sure if it is supposed to run before or after the reboot, but it never runs). This makes it impossible to login/use the web app.
Steps Taken: 1. downloaded the community iso from http://prdownloads.sourceforge.net/efw/EFW-COMMUNITY-2.1.2-200707101220.iso 2. burned the iso (no errors) 3. booted from iso and installed endian (no errors) 4. cd ejected from drive at the "next we're going to set up your isdn..." screen 5. system reboots to a Console with choices: 0) Shell, 1) Restore Factory Defaults, 2) Reboot [*** the setup wizard never runs ***] Additional Notes: -On boot, all four network adapters are correctly recognized -To rule out an error in my ISO, I downloaded again, and tried reinstalling with the exact same problem -I have seen no errors or error screens -as an ancillary note; This machine successfully installed ipcop yesterday (no changes since) and I was able to get to the web app configuration without a hitch System Specifications: [EMAIL PROTECTED], 1Gb RAM, 320Gb EIDE Hard Drive, cd/dvd drive, two Intel PRO/1000 dual port Adapters Any help you can offer will be greatly appreciated, Thanks in advance. Robert Kaye [EMAIL PROTECTED] ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Efw-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/efw-user
