Thanks for your reply ComEd. However if Setup does not run at the end of the install (as is the case here), it makes it impossible to dhcp into the Endian firewall [so it is therefore impossible to http (or https) to the web app].
Furthermore, since the Setup is responsible for setting passwords, one can not ssh to the firewall, nor connect via null modem, nor login at the console. Ancillary additional note I forgot to include in the original problem description: -MD5SUM was correctly matched to the downloaded ISO's [problem can not be an error in download/burning of the installation cd] ------------------------------------------- Cristian-13 wrote: > > Hi Robert. > > After reboot, you have to access de setup via http. > You can achieve this using > http://<lan_ip_configured_in_the_installationProces> > > For example, If you configured the local ip address with 192.168.0.1 you > have to use http://192.168.0.1 to access the setup page. > > > regards > > CC > >>------------------------------------------- >>Robert Kaye wrote: >> Brief Problem Description: >> Community Edition 2.1.2 installation successful to the "setup - >> configuration" point, then reboots to the console without running the >> setup (not sure if it is supposed to run before or after the reboot, >> but it never runs). This makes it impossible to login/use the web app. >> >> >> Steps Taken: >> 1. downloaded the community iso from >> http://prdownloads.sourceforge.net/efw/EFW-COMMUNITY-2.1.2-200707101220.iso >> 2. burned the iso (no errors) >> 3. booted from iso and installed endian (no errors) >> 4. cd ejected from drive at the "next we're going to set up your >> isdn..." screen >> 5. system reboots to a Console with choices: 0) Shell, 1) Restore >> Factory Defaults, 2) Reboot >> [*** the setup wizard never runs ***] >> >> >> Additional Notes: >> -On boot, all four network adapters are correctly recognized >> -To rule out an error in my ISO, I downloaded again, and tried >> reinstalling with the exact same problem >> -I have seen no errors or error screens >> -as an ancillary note; This machine successfully installed ipcop >> yesterday (no changes since) and I was able to get to the web app >> configuration without a hitch >> >> >> System Specifications: >> [EMAIL PROTECTED], 1Gb RAM, 320Gb EIDE Hard Drive, cd/dvd drive, two Intel >> PRO/1000 dual port Adapters >> >> >> Any help you can offer will be greatly appreciated, Thanks in advance. >> Robert Kaye >> [EMAIL PROTECTED] > ------------------------------------------------------------------------- > -- View this message in context: http://www.nabble.com/Install-Problem-%28ComEd-v2.1.2%29-tp15008242p15031048.html Sent from the efw-user mailing list archive at Nabble.com. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Efw-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/efw-user
