Hello All, I did the first part of the mounting and I'm at the stage of Alignment and Test, Part I and yes, I'm almready stuck :-)
Turn on the K2, I ear the relays moving but nothing on the LCD. I did all the checks according to the troubleshooting guide and as I did not find anything wrong I came back to the Front Panel resistance checks. All values are in range except for U1 pin1 where I find more than 1Mohm instead of a value between 25-35K as stated in the check list. I checked U1 for bad solder or bad pin insertion but it seems Ok on this side also. If someone can point me somewhere I can find help or a way to go further... 73, Philippe f8bxi K2 #4068 PS : I ckecked according to the troubleshooting guide that : 000 = OK 050 = OK 060 = OK 075 = OK (i do not ear the 4Mhz oscillator but hecked with a scope and I have an oscillation there) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
