HI Yes if you install the KX60M option then the switching is not required on the antenna because the K2 RF is not required to drive the transverter. The drive comes from the low level output on the KX60M not the K2 finals. The K2 output circuit is turned off when the transverter is selected on the band switch and low level drive is selected in the menu.
The XV144/222 does not have a frequency adjustment for the local oscillator (although the XV50 does) There is an offset adjustment in the K2 transverter menu to compensate for slight frequency variations. This will allow you to adjust the K2 dial indicator to the correct frequency for your transverter. Each of the six transverter menu selections have their own offset setting. Don Brown KD5NDB ----- Original Message ----- From: Paul<mailto:[EMAIL PROTECTED]> To: Elecraft@mailman.qth.net<mailto:Elecraft@mailman.qth.net> Sent: Tuesday, July 06, 2004 8:31 AM Subject: [Elecraft] Transverters Reflector Members, Those of you using Elecraft Transverters........Are all of you using an A/B type switch to go from HF to VHF on the K2' transverter hookup? I was a little surprised to see that to get the Drive RF to the transverters required the use of an external or separate switch that would require the individual to switch from the HF antenna to the transverters with an external switch. Is there any way to use those lower drive RCA connectors to eliminate the switch? Second question - my 144 transverter is about 100 cycles high. Is there a way to correct this? Paul K8QT _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net<mailto:Elecraft@mailman.qth.net> You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm> Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/> _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com