The VCO voltage reading is within the tolerances quoted by Elecraft so is
normal.
However this is not the whole story as you have to look at the results for
all bands rather than just this one and ensure that they also fall within the
stated limits. On my K2 on 40m with 80m set as advised in VCO alignment (P61)
in Alignment and Test, Part II, 7000kHz was below the quoted figure of
greater than 1.5V. This meant a juggling act to balance up the readings.
What I ended up with was:
3500kHz = 2.40V
4000kHz = 6.85V
7000kHz = 1.50V
7300kHz = 2.95V.
On all other bands the VCO voltage readings were well within the tolerances
of greater than 1.5V and less than 7.5V.
Bob, G3VVT
K2 #4168
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
