Bob,
I agree... In my case, the voltage at 3.5 MHz was the ONLY voltage that
was anywhere near a limit.
Thanks, Michael N9BDF
K2 SN #4137
_____
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Sent: Friday, July 09, 2004 8:10 AM
To: Linden, Mike (BRC-Hes); [email protected]
Subject: Re: [Elecraft] K2: Alignment and Test Part II
The VCO voltage reading is within the tolerances quoted by Elecraft so is
normal.
However this is not the whole story as you have to look at the results for
all bands rather than just this one and ensure that they also fall within
the stated limits. On my K2 on 40m with 80m set as advised in VCO alignment
(P61) in Alignment and Test, Part II, 7000kHz was below the quoted figure of
greater than 1.5V. This meant a juggling act to balance up the readings.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
