Well we are moving right along. Just got to the Second aliignment and test section na dthe 4 mhz osc calibration went fine. The PLL reference range test looked good and the range was right in the middle of the road. But when I plugged the freq probe in TP1 and did a cal factor to check the VCO is says 000000.
I am going though all my assembly now to make sure I did not miss anything. Can anyone think of any common mistakes I might be overlooking? Thanks and 73, Rich _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
