Hi The most common problem is with the is T5. Make sure it is wound right and the leads are stripped properly.
Don Brown KD5NDB ----- Original Message ----- From: Rich McCabe<mailto:[EMAIL PROTECTED]> To: Elecraft Reflector<mailto:[email protected]> Sent: Sunday, August 22, 2004 7:42 PM Subject: [Elecraft] Alignment and test part II Well we are moving right along. Just got to the Second aliignment and test section na dthe 4 mhz osc calibration went fine. The PLL reference range test looked good and the range was right in the middle of the road. But when I plugged the freq probe in TP1 and did a cal factor to check the VCO is says 000000. I am going though all my assembly now to make sure I did not miss anything. Can anyone think of any common mistakes I might be overlooking? Thanks and 73, Rich _______________________________________________ Elecraft mailing list Post to: [email protected]<mailto:[email protected]> You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm> Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/> _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
