Hi Everybody. I have just completed the Control board on #3375 and have a question about the resistance checks. Specifically the check on U4, OUT
The manual says to look for 3-7 k at this pin ... and I measure 2.48 k with my DMM. Is this value close enough? Should I be looking for a problem to correct? Thanks for any help. 73/72 Jeff - VA3JFF K2 #3375 KX1 #631 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
