Chuck,
Try reversing your DMM probes - it is possible that no real problem exists.
(the 8T and 8R lines are not used on the Control Board, so the resistance
checks should indicate only that nothing is shorted - the fact that you show
similar reading on both lines - and both show some resistance - cause me to
suspect your DMM)
73,
Don W3FPR
----- Original Message -----
Control Board. All but two of the resistance checks appeared okay.
However
the Q1 Collector and Q2 Collector read 3.5K and 4.5K respectively. The K2
manual states that I should read a value greater than 1M. I will go back
and check for solder bridges etc. again. Any recommendations on what else
that I might check during this assembly stage would be greatly appreciated
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
