I just finished the assembly and resistance checks (IAW page 21) on my K2 Control Board. All but two of the resistance checks appeared okay. However the Q1 Collector and Q2 Collector read 3.5K and 4.5K respectively. The K2 manual states that I should read a value greater than 1M. I will go back and check for solder bridges etc. again. Any recommendations on what else that I might check during this assembly stage would be greatly appreciated
73, KI4DGH Chuck Gehring _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
