On Fri, 21 Jan 2005 00:45:32 +0100, S55M wrote: > OK.I will write it down agn step by step... > > > 1.Turn Power button to 0,1W (full left) > > 2.Press PTT > > 3.When on TX without releasing PTT turn power up over 10W limit to turn on > 100W PA. > > When i do this my K2 stops transmiting above the 10W point (when KPA100 > clicks up). > The only thing to do then is to release PTT and press it again and "voila" > on the AIR again. > > If i go in reverse direction (turning power from 100Wtts to less then 10W) > everything works fine! > > K2 Nr-3204 SW- 1.09 and 2.04 > > It's not a problem but must be a hint..... > > > S55M-Adi > > > ----- Original Message ----- > From: "Donald Nesbitt" <[EMAIL PROTECTED]> > To: "Michael Harris" <[EMAIL PROTECTED]> "S55M" <[EMAIL PROTECTED]> > <[email protected]> > Sent: Friday, January 21, 2005 12:00 AM > Subject: Re: [Elecraft] K2 turning power behavior > > >> Not on mine either. 73 --don n4hh K2/100/KAT100 #2028 >> ----- Original Message ----- >> From: "Michael Harris" <[EMAIL PROTECTED]> >> To: "S55M" <[EMAIL PROTECTED]> <[email protected]> >> Sent: Thursday, January 20, 2005 5:22 PM >> Subject: Re: [Elecraft] K2 turning power behavior >> >> >>> G'day, >>> >>> <snipo> >>> So...if i press the PTT (dot line on keyer when on USB) without talking >>> (or maybe also with ssb modulation because i did not test it) and turn > the >>> power button on 100W and then reduce the power back to minimum my K2 > stops >>> transmitting.I must then release the PTT and press it again to go into > TX >>> mode. >>> Is this happening with all K2's? >>> <snipo> >>> >>> Not on #1400 (external KPA100/KAT100 combo) unless I've read the above >>> incorrectly. >>> >>> Regards, >>> >>> Mike VP8NO >> >> >> -- >> No virus found in this outgoing message. >> Checked by AVG Anti-Virus. >> Version: 7.0.300 / Virus Database: 265.7.1 - Release Date: 1/19/05 >> > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com
Adi, It does that on my K2 with external KPA100 & KAT100 as well. The KAT100 also indicates LOW power on LED until I release, and then press the PTT. Bit of a funny with the firmware. 73 Stewart G3RXQ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
