Thanks for all the help on my blank display problem. I've followed everybody's suggestions. I even resoldered every point. Checked r15&r16. And other things. But when I turn it on I still get the lighted display with no words or anything. And I hear a click a second or two after I turn it on. . .like a relay. I've priced the three biggest chips but it's to much for me to invest for now. The only suggestion I didn't do was to lift the display up to resolder the chip holder that's under it. I'm afraid of breaking the display. Nice looking rig. Sure would like to use it someday. If some of you will recall, I picked this up with the front board and control board complete. I carefully (or so I thought) retraced every step in the manual and am up to phase 1 of the testing and calibration. I made sure every piece was installed correctly (as best as I could being a rookie). I found a couple of things but it was usually just pieces not seated in good, which I fixed. Roland Whitsitt Stockton, Ca. PS.. At this point I wouldn't mind someone coming over here and helping me get past this wall. thanks _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
