In a message dated 18/03/05 17:35:05 GMT Standard Time, [EMAIL PROTECTED] writes:
Thanks for all the help on my blank display problem. I've followed everybody's suggestions. I even resoldered every point. Roland, Check that you have soldered pin 1 on U1, the display driver on the front panel board. A common mistake is missing this soldered joint. I made the same mistake and it can be seen without removing the display. Fixed mine without removing the display, though does need a steady hand. Bob, G3VVT _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
