Congrats, Tom. Do you have the K3 baud rate set to match? CONFIG:RS232? I have N/8/2 for the other parms.
Can you connect to the K3 using the K3 utility? I'm a bit confused if you're having trouble with keying also, or just with the freq/mode stuff. 73, Mike On 8/3/2010 8:05 AM, Tommy Alderman wrote: > I just received a new factory wired K3 (s/n 4521) and I can not get the > K3/Logger to talk to each other. At this point I think the problem with the > K3 (and it's user!) but I am not sure. > Prior to setting up my K3, I had been using an IC-7700, keying with COM1 and > interfacing with COM3, so I know those ports were working. I have a home > brew keying circuit that works with various other programs, so I have no > need to key the K3 through its serial port. > What I have done is moved my keying circuit (it works fine with the K3) to > the K3 and moved my COM3 serial cable to the K3. In Logger Config, I changed > from the IC-7700 to K3, I used the recommended configuration for the K3, > i.e., 19600/N/8/1 and I have DTR and RTS set to 'Always OFF'. The CW/PTT > Port Adr is set for 3E8. > I have tried numerous other settings, N1MM recognizes it is connected to a > K3, but I get no frequency readout. > Sure would appreciate some constructive suggestions or some working > configuration settings! > Tom - W4BQF > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
