I just received a new factory wired K3 (s/n 4521) and I can not get the K3/Logger to talk to each other. At this point I think the problem with the K3 (and it's user!) but I am not sure. Prior to setting up my K3, I had been using an IC-7700, keying with COM1 and interfacing with COM3, so I know those ports were working. I have a home brew keying circuit that works with various other programs, so I have no need to key the K3 through its serial port. What I have done is moved my keying circuit (it works fine with the K3) to the K3 and moved my COM3 serial cable to the K3. In Logger Config, I changed from the IC-7700 to K3, I used the recommended configuration for the K3, i.e., 19600/N/8/1 and I have DTR and RTS set to 'Always OFF'. The CW/PTT Port Adr is set for 3E8. I have tried numerous other settings, N1MM recognizes it is connected to a K3, but I get no frequency readout. Sure would appreciate some constructive suggestions or some working configuration settings! Tom - W4BQF
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
