Only if you are using a serial port rate slower than 38,400 bps. In some future firmware rev of the P3 or K3, this could conceivably go away.
I realize some stations are set up to use a slower data rate. Unless you have a software program that is not capable of operating with a serial port set to 38,400 bps, or have some other technical reason to run slower, I suggest you always use that rate. Even if you don't have a P3 :-) 73, Lyle KK7P >> If you turn the P3 off, then the K3 will be connected to your >> computer through a bypass relay in the P3. You would then >> need to either adjust the computer's data rate setting, or >> the K3's, to match each other. > This is an unfortunate "feature" to have to change the K3 or PC RS232 speed > configuration every time you toggle the P3 on or off. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
