Same here Ed. I now know how to use my logging program at 4800b and then N1MM Logger at 38400b. Very simple once you understand how it works.
73, Tom - W4BQF -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Don Cunningham Sent: Tuesday, September 14, 2010 10:22 PM To: [email protected]; [email protected] Subject: Re: [Elecraft] FW: P3 and K3 RS-232 baud rates Ed, I think you are misunderstanding. You would only have to change the configuration IF you needed to have P3 set to 4800 baud or some other rate than the default 38400. I use P3 and K3 at default rates and have no problems at all, P3 on or off. 73, Don, WB5HAK ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
