Mal: I've had a similar problem when using the XG1 to run the RF Calibration on the SUB Rx (Main works fine). Dick Dievendorff (author of K3 Utility) is aware of the problem and will hand it off to Lyle when he gets back from vacation shortly. 73, Ken K3IU
On 10/21/2010 7:08 AM, Malcolm Rothwell wrote: > After seeing various posts on this subject, thought I'd give it a try. > Unfortunately when I opt for factory defaults and click on "Calibrate" I get > the following error message : E0400E3 ERR DSE on the K3 display and on the > K3 utility I see "DSP command response did not arrive". The radio is > performing normally, should I panic?? > > 73 Mal G4KFT > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
