Malcolm This issue has been resolved with the latest version of the K3 Utility (1.3.10.11). Your firmware is probably OK, but it will do no harm to re-load it before you run the Calibration procedure. 73 Norman - GM4KGK
Malcolm Rothwell wrote: > > Unfortunately when I opt for factory defaults and click on "Calibrate" I > get the following error message : E0400E3 ERR DSE on the K3 display and on > the K3 utility I see "DSP command response did not arrive". > -- View this message in context: http://elecraft.365791.n2.nabble.com/RF-Gain-Factory-Defaults-tp5658229p5658320.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
