Make sure TX TEST is OFF.
If that doesn't work, perform an EEINIT (see the manual index) and do
all calibrations over from scratch.
73,
matt W6NIA
On Sun, 05 Jun 2011 19:36:53 -0400, you wrote:
>
>I am at the point in the construction manual of doing the alignment and
>calibration. I got the synthesizer to align with no problems. However, when it
>came to aligning the LPA I cannot get the K3 to put out any RF. I have gone
>thru the steps about four times, thinking I missed a software toggle somewhere.
>
>OK, here we go:
>
>On pg 49 of the OWNER's Manual.....Under the heading "WATTMETER"
>
>I get to the 4th step: set the power to exactly 5.0 watts and that is where
>things go sideways
>next step: Hold CONFIG & locate the WMTR LP menu, which I can do.
>6th step: Hold TUNE; adjust menu parameter (using VFO A) for a reading 5.0 W
>on the external wattmeter.
>
>I get no RF out of the K3 going to the WM-2 wattmeter. I swapped watt meters,
>coaxial cables and dummy loads but no RF indication on the external wattmeter.
>Not only that I get a " -- -- " on the display where the 14 MHz frequency
>should be displayed when in the transmit mode. I do get the "TX" LED to light
>but, once again, no RF.
>
>Am I missing something?? I am in the CW mode, VOX is "ON",
>
>I have tried pressing on to the TRANSMITTER GAIN calibration, but once again,
>when I hold the TUNE control I get no RF output.
>
>I have the KAT3 installed and "on" and in the "BYPASS" mode.....I can toggle
>between ANT 1 and ANT 2, so something is working on the KAT3....
>
>We leave for Tampa in the morning and I wanted to take the K3 with me and put
>it on the air at my daughter's house. Anyone that can help me figure this out
>PLEASE contact me OFF LIST.....I will repost any comments that provide a
>solution on this list.
>
>Thanks
>73
>Rich Arland, K7SZ
>"Cogito Ergo CQ" ("I think therefore I HAM")
>Bent Dipole Ranch, Dacula, GA 30019
>Author: "The ARRL's Low Power Communications, the Art and Science of QRP" (all
>3 editions)
>Editor: "QRP POWER", QST Magazine (Jan 2000 to Dec 2003)
>Editor: "The Learning Curve", CQ Magazine
>Editor: "The Beginner's Column", CQ-VHF Magazine
>
>
>
>
>
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft@mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
