GM Roger. Did you try the IF menu in setup? If you don't select K3 it won't work. Also, that is where you must select the IF value if you want to use other radios.
Also triple check the cable. 73 Greg AB7R On 7/4/2011 7:03 AM, Roger Banks wrote: > Ok - here's one.... > New P3. K3 1 month old. Both factory built with internal 2m module, KXV3A > etc. > I have no IF display at all on the P3 on any band at any scale level. > Tried rescaling, everything on P3. I have changed IF lead. > If I put a freq counter on the IF out socket from the K3 I get nothing - is > this right? > Can it be switched on and off by the K3 software? I cannot see mention of > this anywhere. > RS232 works and displays freq on P3 OK. DSP widths are showing - everything > by IF signal data. > Any thoughts please? > Roger > GW4WND > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/P3-no-IF-display-tp6546250p6546250.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
