I had to remove the jack screws from the connectors to make a solid connection. They wouldn't allow the connectors to mate deep enough.
On Sat, 25 Jun 2005 05:00:41 +0000, "Jason Marten" <[EMAIL PROTECTED]> wrote: >Sorry to interrupt anybody's field day plans! > >I just built the KIO2, but couldn't establish a connection with >Hyperterminal and K2Remote software. > >So, I went to the DC Voltage chart, and found the following differences (I >used a 13.8 V power supply). (The values with *'s by them in the manual >were pretty close) > >J1-2: -11V, not -8 >J1-3: 0V, not 0.1 >J1-4: 0V, not 4.5 >U1-2: 0V, not 0.1 >U1-5: -11.2V, not -8 >U1-8: -11.2V, not -9 >U1-13: 4.96V, not 4.5 >U1-15: 4.96V, not 4.5 >J2-7: 0V, not 4.5 > >I went to the control board, U6-25 is 5V (someone else on the mailing list >had 0 here for a similar problem as mine). P4-7 on the control board is >also 0V. > >Any ideas? Everything up to now has been working fine. Last thing I added >on was RX160 which I haven't used. Before that, KAT2, which worked fine >(haven't tried it since building KIO2). I haven't noticed any soldering >problems or anything like that. > >Thanks. > > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
