When I built my K1 I actually installed a male connector in the wrong set of holes and was able to successfully remove it without destroying it. I used a large solder sucker (plunger type) and cleared one hole at at time. With a little additional heating and wiggling I was able to pull the header free. I was probably lucky not to have destroyed the board, but it worked.
William, AI4VE ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
