I Just started assembling my KPA500 serial number 0585 this evening. All was going OK until I got to the point where I mount the Z-bracket to the PA/LPF heat sink. The book sez to use 4-40 5/16" black flat head screws. Using this size screw does NOT pull the Z-bracket tight against the heat sink. I've measured these screws three times and I am certain I'm using 5/16" screws. If I use a 3/16" screw, it works fine. Also, I have verified that I've positioned the PA/LPF properly. So, is the documentation wrong, or is this Z-bracket supposed to be wobbly and not tight against the heat sink?
Thanks, Jim / W6JHB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
