Sorry about this, guys - this post went out days and days ago - why it is just now showing up is beyond me.. AND, the problem is fixed.
On Saturday, Dec 3, 2011, at Saturday, 1:31 AM, Jim Bennett wrote: > I Just started assembling my KPA500 serial number 0585 this evening. All was > going OK until I got to the point where I mount the Z-bracket to the PA/LPF > heat sink. The book sez to use 4-40 5/16" black flat head screws. Using this > size screw does NOT pull the Z-bracket tight against the heat sink. I've > measured these screws three times and I am certain I'm using 5/16" screws. If > I use a 3/16" screw, it works fine. Also, I have verified that I've > positioned the PA/LPF properly. So, is the documentation wrong, or is this > Z-bracket supposed to be wobbly and not tight against the heat sink? > > Thanks, Jim / W6JHB > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
