Fixed it. reinstalling the second receiver pulled out a cable to a front panel board and the end was under the receiver so I couldn't see it. Once it was removed, it was obvious. Thanks guys.
73, de Jim KG0KP ----- Original Message ----- From: "Jim Miller KG0KP" <[email protected]> To: "Elecraft Reflector" <[email protected]> Sent: Tuesday, January 03, 2012 7:50 PM Subject: [Elecraft] K3, I broke it. Headed for the schematics > OK, Magic people, I broke it. First responses are the right ones. I > installed the 2m internal module (physically) and the FM Filter. Audio > gone > even before utility ran to configure filters ("all bands"). > > No audio through speaker or headset (front connections) except white > noise, > no signals. I see the signals on my P3 just as they should be. Normal > amplitude, etc. The only connections to the 2 meter module is power, > other > cables not connected. > > Any ideas where the connector is that I somehow disconnected? > > Headed for the schematics. > > Filters were #1 was 2.7, #2 was 1.8, #3 was blank, #4 was 500, #5 was 250 > Filters now #1 is 13.0, #2 is 2.7, #3 is 1.8, #4 is 500, #5 is 250 > In config - just moved settings for #2 to #3 and #1 to #2 and added #1 as > 13.0 and set for FM but NOT installed. > > Thanks es 73, de Jim KG0KP > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
