A common mistake when installing filters is to count left to right, looking at the filter locations on the pc board, instead of right to left. With the front edge of either the K3 RF board or the KRX3 board toward you, Filter #1 goes on the right end. Filter #5 is on the left.
Ron AC7AC -----Original Message----- Jim, Technically, if you hear "white noise", you have audio. Sorry to be so "picky", but it is quite important in troubleshooting to use exact language so we all understand each other. From your statements I would rather have seen you say that you have audio, but do not hear any signals AND that you see signals on the P3. That places the problem between the IF output and the input to the DSP - in other words the filter section of the receiver. Check your filter configuration again, and check the physical installation of the filters - backwards filters do not work right. 73, Don W3FPR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
