I hate when this happens - sort of. After tearing the K3 down I pulled the sub receiver and double checked everything. While at it I decided to move the filter locations in the sub to match the main receiver. I didn't bother to do that last week. Main has 6khz installed, sub does not - so the sub now has a blank in the second slot with all others matching. Reinstalled everything, triple checking and reading instructions over and over. Once installed, same symptoms. Really frustrating. Put a call into the mother ship (Elecraft tech support) and while waiting for the return call, pulled up the K3 Utility and reset the filter locations in the menu. Voila! Sub receiver now works like new. Not complaining but running the utility and ONLY resetting the filter locations should not have fixed anything, IMO. And maybe it didn't - that's the rub.
Thanks for the responses, I checked all the tips and appreciate the combined expertise this list always offers up. Jack - WE5ST ________________________________ From: Monty Shultes <[email protected]> To: Jack Berry <[email protected]> Sent: Mon, January 16, 2012 5:49:24 AM Subject: Re: [Elecraft] Dead Sub Rcvr Jack, Check the antenna connection - a small coax cable connector - at the rear of the 2nd receiver. If that's OK, be sure you have assigned a useable antenna to the 2nd receiver. Monty K2DLJ On Jan 15, 2012, at 8:36 PM, Jack Berry wrote: > Could use some more troubleshooting help. I'm hoping to find a cable left > disconnected but doubt it. Any tips on where to look greatly appreciated! > > I added a few mods to my K3 last Friday & just getting around to running >through > > all the features - shake down cruse. I find the sub receiver, which was > working > > fine before is now silent expect for some odd spaced spurs in a couple of >spots. > > It's the same on all bands checked. All else seems to be working well > including > > the added components. > > I had to pull the sub receiver while installng an AM filter in the main > receiver, the KXV3 I/O module, KDVR3 recorder module, DSP board upgrade and > installed KTCX03-1 temp controlled xtal oscillator. > > I will open the case again tomorrow when I'm fresh and have time to go over > my > work carefully. > > > Wish me luck and again, thanks for any advice. > > Jack - WE5ST > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
