Tim, Make sure you have MIC SEL on the MAIN menu set to PH+Line-In. This allows the back line-in jack to be active for transmit/receive on the back panel Line-In port. I also use the SignaLink with my K3 and don't have any issues with this setting.
Hope this helps. 73, --Ian Ian Kahn, KM4IK Roswell, GA EM74ua [email protected] K3 #231, P3 #688 On Wed, Jan 25, 2012 at 10:45 PM, Tim Urban <[email protected]> wrote: > Trying to run my K3 on PSK31 in data A mode w a tigertronics USB interface > and digipan software. > > The box connects to K3 via line in/out jacks and the rear panel PTT jack. > All jumpers in interface are set correctly. When the software goes to TX, > the interface box goes to TX, and the phono plug from the box that plugs > into the K3 PTT jack goes to ground. > > The K3 however doesn't go into TX mode, unless you also key the hand mike. > > Using the hand mike switch as a manual PTT switch I made several PSK31 > QSOs tonight so the sound card chip in the tigertronics box is apparently > working. > > Just for kicks I tried using the rs232 rig control and digipan to try to > trigger TX that way as described in elecrafts K3 operating hints, and the > rig would not go into TX mode that way, either. > > Is there a selection in the menus that I am overlooking that will allow > the rear panel PTT jack to trigger TX mode while in Data A? > > 73 > > Tim > N5IIT > > > > No Message Below This Line > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
