It should be flat. Is anything caught between the Z-bracket and the bottom cover?
Ron AC7AC -----Original Message----- Just finished a KPA500 build and all went smoothly. The only issue I see is that the Z-Bracket appears to be about 1mm taller at the front than at the rear. The result is that the top cover protrudes above the front panel in the center by a small amount, perhaps 1mm. At the rear the top cover is flush with the rear panel in the center...no protrusion at all. This is a cosmetic issue but does detract a bit for the "fit and finish" of the rest of the KPA500 and the K3. Has anyone else seen this issue? Thought I would ask before calling home. --- Chuck, AE4CW ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
