On Fri, Feb 10, 2012 at 6:54 PM, Chuck - AE4CW <[email protected]> wrote:
> Just finished a KPA500 build and all went smoothly. The only issue I see is
> that the Z-Bracket appears to be about 1mm taller at the front than at the
> rear. The result is that the top cover protrudes above the front panel in
> the center by a small amount, perhaps 1mm. At the rear the top cover is
> flush with the rear panel in the center...no protrusion at all. This is a
> cosmetic issue but does detract a bit for the "fit and finish" of the rest
> of the KPA500 and the K3.
>
> Has anyone else seen this issue? Thought I would ask before calling home.
Yes, I have exactly the same issue, but I don't have a solution. It
hasn't bothered me enough to pursue it with support, but I couldn't
see any way that it could have been caused by incorrect assembly, so
it must be a malformed Z-bracket.....
Let me know if you find a solution!
~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
