Hi Chuck, Yes I have exactly the same issue with my KPA500.
73 Roger MW0IDX On 11/02/2012 02:54, Chuck - AE4CW wrote: > Just finished a KPA500 build and all went smoothly. The only issue I see is > that the Z-Bracket appears to be about 1mm taller at the front than at the > rear. The result is that the top cover protrudes above the front panel in > the center by a small amount, perhaps 1mm. At the rear the top cover is > flush with the rear panel in the center...no protrusion at all. This is a > cosmetic issue but does detract a bit for the "fit and finish" of the rest > of the KPA500 and the K3. > > Has anyone else seen this issue? Thought I would ask before calling home. > --- > Chuck, AE4CW > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
