Try using the serial port to set PTT instead of the SignaLink. Ignore what the HRD help file says about using the SignaLink PTT and use the serial PTT for digital modes and CW (KY Cmd) for CW.
If sending digital in HRD, pressing the F1 key enables the transmitter until ESCape or F2 AND no more data. F2 goes to receive at the end of the data (empty buffer). Rick WA6NHC -----Original Message----- From: Bryon I've been using HRD and my SignaLink with an Icom radio. I recently upgrade to a K3 and got everything hooked back up with the new cables. PTT connector on the SignaLink cable is also hooked up to the rear panel. I send just find, PTT on the SignaLink comes on, the Radio TX light comes on it sends the SignaLink PTT light goes off and the radio stays in TX. I can then hit XMIT and it stops. Any suggestions? - - Bryon ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
