I use FLDigi, but I had the exact same problem. You need to disconnect the PTT jumper inside the SignaLink. It's easier to just disconnect the PTT connector from the back of the radio if you don't need it. I needed my PTT lead for an external KAM+.
For PTT, you need to use the program. I'm not sure how HRD does it, but I have successfully made WL2K and JT65-HF key my K3 without the PTT jumper inside the SignaLink. Joel - W4JBB On 2/21/2012 10:34 PM, Bryon wrote: > I've been using HRD and my SignaLink with an Icom radio. I recently upgrade > to a K3 and got everything hooked back up with the new cables. PTT > connector on the SignaLink cable is also hooked up to the rear panel. > > I send just find, PTT on the SignaLink comes on, the Radio TX light comes > on it sends the SignaLink PTT light goes off and the radio stays in TX. I > can then hit XMIT and it stops. > > Any suggestions? > > - - > Bryon > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
