I installed the P3SVGA board in my unit yesterday. On mine, it also does not display properly in 1920x1080. I have an Acer H243H monitor. It natively supports "Full HD", 1920x1080p. When I set the P3 SVGA output to 1920x1080, the monitor confirms that it has switched to that resolution. However, the P3 image appears to extend off the right of the screen. That is to say, the full span to the right is not displayed. The vertical span is fine. There also appear to be small white dots moving horizontally through the spectrum portion of the display, as if the display is "wrapping" somehow. (This is no doubt an inaccurate description, but the best I can do. I have tried reloading all firmware (1.12) and FPGA files to no effect.
Note that the monitor displays my PCs output at 1920x1080 using the DVI (rather than VGA) input with no problems, so I know the monitor is capable. For now, I am running at 1440x900 from the P3 with no problems. 73, Bruce, N1RX > 1080 overflows my 1080P monitor also. <snip> > Rick > K6LE ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
