All- Thanks for sharing.
My newly acquired normal use headset is the HC5 proset and I was wondering what settings I should utilize. This is great information. My other headset the proset with HC4 I use once in awhile for other purposes. Thanks again, Keith Sent from my iPhone please excuse typos On Mar 28, 2012, at 9:35 AM, "Joe Subich, W4TV" <[email protected]> wrote: > > John, > > When I had the Proset with HC-5 element I used almost the same TX EQ as > I currently use with the CM-400 - just a bit less preemphasis at the > high end. > > The HC-5 settings were: > > 50 -16 > 100 -16 > 200 -6 > 400 0 > 800 0 > 1600 +3 > 2400 +5 > 3200 +6 > > Effectively, 65 db/octave roll off below 400 Hz to reduce the bass > boost from having the mic close to the mouth and a 3 dB/octave boost > above 800 Hz. With the CM-400 or other mics not designed with an > "articulation peak" at 3 KHz I increase the pre-emphasis slope to > 6 or 9 dB/octave (6dB/octave is usually sufficient unless the mic > has a severe high frequency problem). > > 73, > > ... Joe, W4TV > > > >> On Mar 28, 2012, at 6:31 AM, WB9JPH wrote: >> >>> Looking for any hints on tweaking the audio settings for the K3 with the >>> Heil HC 5 mike element. >>> >>> Rather than just grabbing numbers out of the air, I'd like to start with >>> settings that have worked for you and go from there. >>> >>> 73 >>> John >>> >>> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
