Ok, Let me start again, but this time from the computer. I have a Elecraft K3 and it is hooked up to a signalink. Going to my lap top which is running a older version of HRD. I decode PSK31 fine business. I am putting out about 25 watts and have yet to make a contact. I did name a contact on CW, but everything I try in PSK doesnt work. I check out what Don had told me and I do not have anything showing on the ALC in Data A mode. No matter if I turn up the line in gain or the tx knob on the signalink. My output meter shows 25 watts, but no alc. The compression is off. and I have the center marker set for 1500 on the software.
agc is fast. atu in active, swr on 40 meters is 1.0 - 1 and am using fl1 2.8 as the transmit filter. hope this helps explain some, so I can try to figure this out. Thanks for all the replies and help. nice to have this reflector and a great bunch of hams on here. any and all ideals are greatly appreciated. Gerald - KC6CNN -- View this message in context: http://elecraft.365791.n2.nabble.com/what-am-I-doing-wrong-tp7493647p7494185.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
