Absent the referenced document, possibly the information you seek is in the KX3 Owner's Manual. Specifically on page 31: "If you install a KXFL3 roofing filter during KX3 kit assembly, or install one in a factory assembled KX3 after initial purchase, you’ll need to perform the Receive Sideband calibration step (pg 32)."
If these are both the same thing, then possibly the assembly manual could also be adjusted: "2) If you installed the KXFL3, calibrate it as shown on the instruction sheet supplied with the KXFL3 module or as shown in the Calibration section of the KX3 Owner's Manual." Hope this helps! 73 de JP WF4Z On Wed, May 16, 2012 at 4:04 PM, Bruce Beford <[email protected]>wrote: > At the end of the KX3 assembly manual, the following statement is seen: > > 2) If you installed the KXFL3, calibrate it as shown on the instruction > sheet supplied with the KXFL3 module. > > I note that the instruction sheet for the KXFL3 module is not yet available > on the Elecraft manuals download page. Could it be posted please, for > download and review of these calibration instructions? > > Thanks, > Bruce, N1RX > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
