Bruce, The instructions have changed. Did you receive a KXFL3 option quite recently? If so, there should have been a small 2 turn loop antenna supplied with it - along with the instructions.
I do have a preliminary copy of the instructions - because I field tested those instructions. If you have a real need to obtain them, send me an off-list email - actually I was hoping someone at Elecraft would answer you and could likely give you more updated info, but I think the key players in this are getting ready to go to Dayton and don't have time to read the reflector. 73, Don W3FPR On 5/16/2012 4:04 PM, Bruce Beford wrote: > At the end of the KX3 assembly manual, the following statement is seen: > > 2) If you installed the KXFL3, calibrate it as shown on the instruction > sheet supplied with the KXFL3 module. > > I note that the instruction sheet for the KXFL3 module is not yet available > on the Elecraft manuals download page. Could it be posted please, for > download and review of these calibration instructions? > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
