See inline for comments -----Original Message----- From: Toby Pennington [mailto:[email protected]] Sent: Sunday, 29 July 2012 10:42 AM To: Adrian Subject: Re: Emailing: k3fw4r47.zip
I have successfully downloaded 4.47 after crashing the radio once but came back according to your input and 4.47 loaded in. Disconnecting the P3 before K3 power up, after a mcu ld issue is required and I forgot to mention that. Plug P3 supply back after the K3 firmware has been completed. Sounds like you were good, but I just remembered that. Now, I am wondering what settings you have in your rig which gives you really good decode. I am working on that now. I have the AGC threshold set to 8 with the SLP set to 7. Set SLP to 0. AGC at 8 is good. I have theTEXT DEC set to threshold of 5 and 30 to 90 wpm. Yes the 30-90wpm works the best even at slow speeds. I use a narrow filter. Set threshold for clean pulses on the cwt display after spotting (centre) the signal. Then use filter width and/or rf gain to fine tune. I get perfect results most of the time, and using this method on noisy lower bands works well. Just check the cwt is pulsing with the cw, then you are close. The fine tune is reflected in the print. I just noticed my P3 cursor will not move so have another issue HI> Check for tracking mode or disable re-enable svga etc. Good Luck Adrian ... vk4tux ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
