Hi Toby, I'm not much into psk31 etc these days. I tried it out yrs ago and got bored fast.
For RTTY the CWT twin tune bar should carry even bar weight each side to coincide with best copy. However the P3 green line and shade area does not match up well with the twin dropper signal when this happens. It's sort of get the green line to the right of the right dropper to get into the ballpark. It would be nice to get a P3 visual marker in RTTY that could be lined up better. I found a copy of 4.48 & installed, I have most of the old firmware versions on my pc saved. 4.50 came out next with the agc deal and bad decode and so on. Adrian.vk4tux From: Toby Pennington [mailto:[email protected]] Sent: Monday, 6 August 2012 12:30 AM To: Adrian Subject: Re: [Elecraft] P3SVGA data RTTY FSK D Hi Adrian, I wnet back to 4.47 Firmware in the K3 and find decoding on the P3 is improved. CW operation with the P3 is perfect and no issue. On PSK I have made contacts but it seems my TX freq is slightly off from my RX freq. I have tried the Reference Freq. calibration and can make changes to center the received signal. I have the SPAN set to 5KHZ for PSK and find that allows me to see all the signals better. I wonder if you have had any experience with PSK? I have not tried RTTY yet. Toby W4CAK ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
