Hi Scott, I'm going to assume you are talking about a K3 here (red light comes on). I'm successfully running WSPR here on K3 #338. Here is my setup:
- Using DATA A mode (make sure you're not in REV DATA). - While in TEST mode, I adjusted my sound card output to show a solid 4 bars on the ALC meter with the 5th bar flickering. - Adjust the CONFIG:LINE OUT so that you see around 0db RX noise displayed at the bottom of the WSPR application while it is receiving. I'm currently testing a new antenna on 40m running 1W. I will be around this morning if you would like me to monitor you or offer any other suggestions. Hope this helps. 73, Dave W8FGU On 8/13/2012 8:13 AM, Scott Dunlavey wrote: > Hello ... > I seam to have something set wrong... I can rx and tx while doing > PSK/RTTY... BUT doing WSPR I don't seam to be heard and I cant hear... > It acts like it is transmitting.. (red light comes on) and I hear the > packet bursts... what could I be doing wrong > > scott > w2ntv > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
