Hello Tom I run the K2 and psk31. It's fun, just remember set your power low. 5 watts on k2/10 . As far as the mic, I am not sure. Good luck hope to see you on the waterfall. KC6CNN On Nov 27, 2012 5:30 PM, "Tom McCulloch" <[email protected]> wrote:
> > Hi gang, > I have a very old Rig Blaster interface that uses jumpers to match the > transceiver's microphone to the Rig Blaster outputs. The instructions are > quite old and they don't list the jumper configuration for Elecraft rigs. > I seem to remember that the K2 mic jack is configured the same as a > Kenwood. Could someone please verify this for me. > > Also, is there anything I should know about running psk31 with a barefoot > K2? > > Thanks in advance. > > Tom, WB2QDG > K2 #1103 > > > ______________________________**______________________________**__ > Elecraft mailing list > Home: > http://mailman.qth.net/**mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> > Help: http://mailman.qth.net/mmfaq.**htm<http://mailman.qth.net/mmfaq.htm> > Post: mailto:[email protected].**net <[email protected]> > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
