On 11/27/2012 3:30 PM, Tom McCulloch wrote: > I have a very old Rig Blaster interface that uses jumpers to match > the transceiver's microphone to the Rig Blaster outputs. The > instructions are quite old and they don't list the jumper configuration > for Elecraft rigs. I seem to remember that the K2 mic jack is > configured the same as a Kenwood. Could someone please verify this for me.
Sorry that the other replies misinterpreted your question. I run an "old" RigBlaster Plus with my K2, and the RB should be jumpered for Kenwood 8-pin round if your K2 is set correctly. I don't have the manual handy but it should be av available on line from the WestMountain site. Have fun! 73 de K2ASP - Phil Kane Elecraft K2/100 s/n 5402 >From a Clearing in the Silicon Forest Beaverton (Washington County) Oregon ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
