Well, my KAT2 saga continues.
I did indeed find some unsoldered pins on one of the relays, and corrected this. Now, however, I seem to have the opposite problem. When trying to perform the CALn procedure, instead of having too much reflected power, I now have no power (forward or reflected) at all; '000' shows all the time on the LCD display, no matter what I do to C55 does and no matter what the Power level is set to. The DC voltages on the REFL and FWD signals paths are zero now. I have checked and rechecked for solder bridges, cold joints and shorts/continuity on the RF cable and control cable, and am running out of ideas (and my sanity)! ------------------------------------------------------------------------------- This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ==============================================================================
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
