The first thing that occurs to me is that the single turn of wire through the center of T1 may be missing. The second thing is that T1 itself may not be properly wound or properly soldered. Check that the proper color wire is inserted into the proper holes (the color of the wire in hole 2 should be opposite of the color in hole 3).
Other than that, there is not much that would produce no voltage out of the wattmeter, but check the soldering and orientation of the diodes. 73, Don W3FPR > -----Original Message----- > > Well, my KAT2 saga continues. > > > > I did indeed find some unsoldered pins on one of the relays, and > corrected this. > > > > Now, however, I seem to have the opposite problem. When trying to > perform the CALn procedure, instead of having too much reflected power, > I now have no power (forward or reflected) at all; '000' shows all the > time on the LCD display, no matter what I do to C55 does and no matter > what the Power level is set to. The DC voltages on the REFL and FWD > signals paths are zero now. I have checked and rechecked for solder > bridges, cold joints and shorts/continuity on the RF cable and control > cable, and am running out of ideas (and my sanity)! > > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.344 / Virus Database: 267.11.1/104 - Release Date: 9/16/2005 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com