R6 is currently uninstalled ... I am still trying to do the CALn null adjustment ... as I said, instead of having HI showing up continuously, I know have only '000' on the display. (I don't know if this is significant, but the manual says the display should look something like '075 ATU' but I only see '000', not '000 ATU' ...
In any event, I have checked T1 3 times already, reheated the leads, made sure the green jumper cable across it is in place ... again checked continuity of the RF cable .... and of course checked for the 3rd time that the ground and hot leads weren't reversed ... Gonna pull it apart again and look at the soldering on the relays AGAIN ... this situation changed when I soldered a row of pins on one of the relays that I had missed .... I think I was better off when they ere unsoldered! At least I had SOME output! :-) -----Original Message----- From: k4zm [mailto:[EMAIL PROTECTED] Sent: Saturday, September 17, 2005 4:28 PM To: Sanger, Joseph Subject: Re: [Elecraft] KAT2 - Bridge Null Adjustment problem Have you installed R6 yet? Page 17 - 5th step is to install a 47 ohm 1/4 watt resistor in the KAT2. This is the info to the K2 microprocessor to set the power level out of the K2. 73 Jim K4ZM ------------------------------------------------------------------------------- This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ============================================================================== _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
